Mike Brady Posted May 21, 2018 Report Share Posted May 21, 2018 (edited) My 1953 Job Rated does not have its bench seat it only has the frame that is built into cab. What are some options for making or using another truck seat? Exact replacement is almost impossible to find. Edited May 21, 2018 by Mike Brady Grammer Quote Link to comment Share on other sites More sharing options...
Merle Coggins Posted May 21, 2018 Report Share Posted May 21, 2018 Take that frame out and get out your tape measure. There are plenty of seats that can be made to fit. There should be 2 bolts at each corner that attach the seat frame to the riser. Pretty easy at this point with out the cushions. 1 Quote Link to comment Share on other sites More sharing options...
NiftyFifty Posted May 22, 2018 Report Share Posted May 22, 2018 It was more work, but I cut out the whole support and installed power leather bucket seats and a centre console, about the only bench seat you will likely find to fit will be mini van or suv, I think a new 1/2 ton bench would be too wide 1 Quote Link to comment Share on other sites More sharing options...
kencombs Posted May 22, 2018 Report Share Posted May 22, 2018 Take a look at 90s Ford Ranger 60/40 benches, they look very close to the right size. Quote Link to comment Share on other sites More sharing options...
JBNeal Posted May 22, 2018 Report Share Posted May 22, 2018 If browsing at the salvage yard, pay attention to the floor of the donor vehicle as well. A flat floor minivan bench should yield a closer fit than bucket seats from a contoured floor sports car, for example. (I replaced the bench in my Dakota years ago with very comfortable Shadow buckets, but the seat angle was a little off cuz of the Shadow floor pan not being as flat as the Dakota's...lesson learned ⚠️) Ya might need to mock up something to measure a comfortable seat height so your knees are not up in the steering wheel, then you should have the dimensions you need to find a donor. Quote Link to comment Share on other sites More sharing options...
Brent B3B Posted May 22, 2018 Report Share Posted May 22, 2018 my b3b had the wrong bench seat bottom in it. I pulled the frame and took it to the upholsters and had him make the seat fit the frame. he built it on a plywood base.... I fabricated up some metal adjustment slots to attach it to.... that thing is solid! 2 Quote Link to comment Share on other sites More sharing options...
buds truck Posted June 24, 2018 Report Share Posted June 24, 2018 if you still need the seat, I have a couple of them. one is the "air ride" option seat. Quote Link to comment Share on other sites More sharing options...
Mavman427 Posted July 30, 2018 Report Share Posted July 30, 2018 On 5/22/2018 at 8:21 AM, Brent B3B said: my b3b had the wrong bench seat bottom in it. I pulled the frame and took it to the upholsters and had him make the seat fit the frame. he built it on a plywood base.... I fabricated up some metal adjustment slots to attach it to.... that thing is solid! Are there any springs in that lower seat or just foam over the wood base? Quote Link to comment Share on other sites More sharing options...
Brent B3B Posted July 30, 2018 Report Share Posted July 30, 2018 both springs and foam Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.