So you think you are fast at working on you car...

[dezeldoc]

Here is some fast guys!!

http://www.youtube.com/watch?v=lgwF8mdQwlw&feature=player_embedded

Edited September 13, 2010 by dezeldoc

[Merle Coggins]

I watched it a couple of times and I still don't see anyone disconnecting or reconnecting a drive shaft. How do they drive it in and out?

[Young Ed]

That was my thoughts too Merle. Of course if you have the right kinda slip joint you'd just have to make sure you lined it up when you put the rear end back in place.

[Merle Coggins]

That's what I was thinking. Must have a shaft suspended in the frame so that they can slide the trans into it at one end and the rear axle into it at the other end. Also, no coolant in it either. They must not drive it far.

[desoto1939]

I personally seen a club from MD dothe same with a Model T. I can not remember the time limit but it is very fast.

Rich Hartung

[greg g]

lots of clevis pins.

[Oldguy48]

No matter how they did that...that's impressive. Wow !!

[dezeldoc]

OK lets go a little farther; brake lines, radiator hoses, steering, wiring and a whole list i can think of.

[P-12 Tommy]

lots of clevis pins.

That's what I'm thinking! Cool video.

Tom

[LAKOTA169]

Think they learned that in Detroit.