Miller Trubrake System documentation

[desoto1939]

I was going through a 1935-36 Plymouth service manual and at the back of the manual was section on how to use the Miller MT19 Brake gage tool and the Miller Trubrake tool to perfectly arc your new bakeshoes.

 

I have both of these special tools the Miller MT19 with the 7 sleeves and the Truebarke tool to cut down the lining to match the arc of the drums.

 

Please read the copies of the explanation of the process.  These tools were the factory dealership tools that were used from the mid 1930's up to around 1955 while MoPar was still using the Lockheed Brake system with the eccentric pins. The tool will work for both single and dual wheel cylinders.

 

I have used the MT19 to setup my brakes and then used the grinding tool to arc the lining to fit the arc of each drum.

 

 

Truebrake system.pdf

[desoto1939]

here isa picture to the truebrake lining cutter.

 

Rich Hartung

[Dodgeb4ya]

Another version of the Trubrake grinder is the "Brake DokTor"

Looks very similar. I used to use one years ago.

The bench top machines are easier and quicker to use and get abrasives though not done much these days.

I use ammco and star grinders still.

[desoto1939]

Yes the dust is an issue but I wear a face-shield and also mask when using  the tool. I am very carful when using  the tool just as you have to be when working under a car.

 

You do not see many of these two tools even at Hershey.  The older Miller tools are very hard to find. everyone wants the Ford or chevy Gm tools.  So i might never have to do another brake job but the history of the tool and knowing how they did this back when these cars were being serviced is such an experience.

 

Rich hartung

[MarcDeSoto]

I found an old brake shop in Long Beach, C. H. Topping, and they were the only ones who could arc my brake shoes.  They are the perfect place to take an old car for a brake job because I looked around and saw nothing but old cars like a 40 Ford and 57 Pontiac etc.  But they have about a two month waiting list of customers.  

 

https://www.longbeachexecs.com/automotive/item/167-c-h-topping-brakes

[greg g]

C H Topping are the ones that had an article touting their process of drilling drums to improve braking performance.   This procedure allows for better brake cooling and allows for the release of gasses built up from the action of friction on the lining material which helps proper surface contact between shoes and drums.

 

I believe a copy of the article is in this site's download files.  Apparently  this was a thing before retro fitting disc brakes became the preferred brake up grade. 

 

This process was used to good effect in the early50's for American cars running in the Carrara Pan Americana, aka the Mexican Road Race.

 

Didn't know they were still open.  Somebody  in So Cal should drop of their 40's Dodge or Plymouth and have the process done and report the results.

 

 

Edited February 18, 2023 by greg g

[harmony]

Has anyone here ever tried the process of drilling holes in the drums themselves?  I couldn't find the article in the download section here by C H Topping that greg g was referring to, but I did find it on line.  Looks like they drill about 38 holes, using 2 rows with staggered holes.  Perhaps 2 1/2" between holes.  Looks like maybe 1/4" holes. 

 http://www.chtopping.com/CustomRod4/