TylerB46 Posted June 7, 2018 Report Posted June 7, 2018 Hey folks I’ve slowly been putting my 46 wc truck back together, and I finally got around to getting the clutch and brake pedals back on the clutch fork. Well I got everything back on with no issues, but when I went to connect the master cylinder to the brake pedal, the little pin that you push through hits the clutch pedal and binds them both up. I’ve uploaded a pic of what I got, do any of you know of what’s causing this issue? Quote
JBNeal Posted June 7, 2018 Report Posted June 7, 2018 The spacer between the shaft base and brake pedal does not appear correct...there should be a spacer between the pedals, but only about half as thick as that greenish one...try halving that spacer and placing on both sides of the brake pedal Quote
TylerB46 Posted June 7, 2018 Author Report Posted June 7, 2018 57 minutes ago, JBNeal said: The spacer between the shaft base and brake pedal does not appear correct...there should be a spacer between the pedals, but only about half as thick as that greenish one...try halving that spacer and placing on both sides of the brake pedal Is the spacer that’s on the shaft base not supposed to be there, or are there two spacers? Quote
ggdad1951 Posted June 7, 2018 Report Posted June 7, 2018 I can take a pic tonight if no one else has. Quote
TylerB46 Posted June 7, 2018 Author Report Posted June 7, 2018 Just now, ggdad1951 said: I can take a pic tonight if no one else has. That would be great if you could. Quote
Merle Coggins Posted June 7, 2018 Report Posted June 7, 2018 Mine is different, with Fluid Drive, but I'm thinking the spacer should be between the pedals, not between the brake pedal and the shaft support bushing. On the B-series trucks parts manual it shows a support bracket between the pedals, but otherwise a similar setup. Quote
Dodgeb4ya Posted June 8, 2018 Report Posted June 8, 2018 (edited) There should be a brake and clutch pedal re-enforcement cast iron two bolt bracket that bolts to the bottom of the bell housing and curves up to the clutch pivot shaft ....it fills a 3/8" space It actually slips over the pedal shaft and goes between the two pedals. I looked thru all my W- series books no clear picture of the pedal assembly even in later books.... shop and parts. Edited June 8, 2018 by Dodgeb4ya Quote
HotRodTractor Posted June 8, 2018 Report Posted June 8, 2018 Here is a picture off of one of my parts trucks. Spacer in between the two pedals. Quote
TylerB46 Posted June 8, 2018 Author Report Posted June 8, 2018 37 minutes ago, HotRodTractor said: Here is a picture off of one of my parts trucks. Spacer in between the two pedals. That’s what I needed, thanks! Quote
JBNeal Posted June 8, 2018 Report Posted June 8, 2018 Fluid Drive configuration with cast bracket Quote
ggdad1951 Posted June 8, 2018 Report Posted June 8, 2018 21 hours ago, TylerB46 said: That would be great if you could. others beat me to it! Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.