Jump to content

Recommended Posts

Posted

I have an old box of NOS Autolite spark plugs AR 10.  Should I use these in my rebuilt 1948 DeSoto engine, or buy new ones?  When I open each box, the spark plug is wrapped up in a paper coupon that can be turned in for prizes.  The coupon says it expires on December 31, 1945!   I guess I'm a bit late for the prizes.  

P1030045.JPG

P1030046.JPG

  • Like 1
Posted

They look a bit rusty so I would clean them up so you have a good ground. There isn't anything perishable inside so they should be good to go.

Nice touch for a concourse event.

Posted

what gap are you planning to use. Might have to be set at 35 for the resister plug versus regular at 25.

 

Rich Hartung

Posted
19 hours ago, MarcDeSoto said:

 

I found out that most of the NOS plugs are A7 plugs, so not resistor.  I guess you should use resistor if you plan to play the radio?  I still have an A-5 plug from the 80s.  Do they still sell them?  Should I use a normal plug or the hotter plug on a rebuilt engine?  

Posted

A7 was the standard Autolite plug for our cars. The A9 is a hotter plug  both of these are non resister plugs. My friend that has a 39 Desoto is running the Autolite 297 plug and you can get them at Walmart they are a small engine plug and cross over and cost around $2.90 a plug.

 

Rich Hartung

Posted
7 hours ago, MarcDeSoto said:

Should I buy resistor plugs if I am going to play the radio?

 Resistor plugs help suppress spark plug noise, a valuable trait under certain circumstances. However I had a 1965 Plymouth Barracuda with a 225 slant 6. I did not use resister plugs and my AM radio worked fine with no interference from the plugs. I had problems with the FM band and resister plugs were needed.

Posted

They make a radio condensor that goe on the generator that is used to supress the static from the plugs. That is what came with my 39 desoto since the original owner had the factory radio installed and it does work and then you can use regular plugs instead of the resiter plugs.

 

Rich Hartung

Posted

There are several sources of potential interference. 

 

Ignition noises, sounds like crackling/popping.  Resistor plugs and wires for that and a cap on the coil supply side terminal if it's bad enough.

 

Wires and plugs can act as antenna radiating the noise as RF and the radio picks it up with it's antenna, the resistance takes care of that.  Noise can also feed back in the electrical system, the cap takes care of that.

 

The alternator/generator, sounds like a whine that varies with RPM. It can be a back diode, if it's an alternator, otherwise a cap on the output for that.

 

Pick your poison https://www.summitracing.com/search/part-type/noise-filter-capacitors

 

 

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...

Important Information

We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue.

Terms of Use