Jump to content

Rear axle bearing cups / end play


Recommended Posts

Posted
6 minutes ago, Dodgeb4ya said:

Axle end play specs grew on the mid to late 50's cars..     .013" to .018"

 

I wonder if that was due to higher speeds available with v8's?

Posted
1 minute ago, Sniper said:

 

I wonder if that was due to higher speeds available with v8's?

I think that is the answer.

Posted

It did not have anything to do with V8's. The tech note, the best I remember, said that due to the New Interstate Highway System that sustained higher vehicle speeds were causing the heat in the axles and they elongated. This caused them to bind on the stop or rubbing block in the differential. Therefore they added more end play.  It is function of sustained speeds not engine type or size. I know we all run out flathead six's down the freeway at 65 and 70 all the time and that would have been very unlikely in the late 1940's.

 

James

Posted

The modern V8's certainly had an effect...caused higher attainable and longer constant high freeway speeds.

The old obsolete wimpy flatheads didn't have enough power to heat up those rear ends causing elongated axle shafts ha ha that needed up to an additional .010" clearance.

 

Posted
On 11/7/2021 at 11:46 PM, Dodgeb4ya said:

The modern V8's certainly had an effect...caused higher attainable and longer constant high freeway speeds.

The old obsolete wimpy flatheads didn't have enough power to heat up those rear ends causing elongated axle shafts ha ha that needed up to an additional .010" clearance.

 

I disagree.

 

It is not the engine HP it is the speed down the road for a sustained time. Case in point is my bad ring and pinion gear in the '47 Desoto. I can run it for short amounts of time here in San Francisco and it is fine. After about 10 minutes running down the freeway it heats up and starts to howl.

 

It is function of the cars speed. I run my flathead for hours at 65 on the freeway.

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...

Important Information

We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue.

Terms of Use