Rubber hood bumpers on P15

[BobT-47P15]

Was looking up some info on rubber hood bumpers on a P15 for Tim a couple days ago......and learned something new myself.

Had not really studied on how many of those little round bumpers came on these cars. The answer is four per side. Three larger (thicker) and one real thin one.

You can see the frontmost thick one.....and ball point pens marking the holes where the other two go.

The front (thin) one is on the curve of the fender. Just in case anyone wants to know. Don't know a handy source for these, however.

[Young Ed]

I found some tall ones that were really close at the hardware store. I think I had to reuse the short ones though.

[bobby horne]

.....I used the part of a valve stem that I cut off a wheel to put new valve stems on. If they are too thick, a sharp razor blade will shave them.

[Brendan D25]

Bobby, that is a good idea. Is that a ferret keeping guard over your car?

[55 Fargo]

Brendan sent you a PM, and replied to your post on 40s Canadian Chrysler

[Plymouthy Adams]

hey..my little guy wants to know if yours is a female??????

Don C. has one of these guys..it is male and has seen things it should not have been subjected to..(see other message on why should not give advice)

[Frank Blackstone]

I got my rubber hood bumpers at Restoration Specialists. Did not notice a thin one but ones I got work well. Remember the ones that separate the rear bumper shelf between the trunk body and the bumper. Frank