greg g Posted August 14, 2017 Report Posted August 14, 2017 Let em click, better a bit loose and noisey than quiet and too tight. 1 Quote
bambamshere Posted August 14, 2017 Author Report Posted August 14, 2017 1 hour ago, greg g said: Let em click, better a bit loose and noisey than quiet and too tight. Ya but I'm the type of person that it will drive me crazy. But I can't do anything till next year anyways. I need to stop buying stuff for this truck and actually start eating. Lol start to become a addiction I will by the new coil next month and that will be it. My everyday vehicle os starting to suffer. Winter is coming Quote
DJ194950 Posted August 14, 2017 Report Posted August 14, 2017 If you call Pertronix ask them if you Need a resistor in the setup. Many do Not want or need a resistor on them, but need a full 12 volt. Sometimes it depends on the coil used - I think---. DJ Quote
bambamshere Posted August 17, 2017 Author Report Posted August 17, 2017 So haven't had time to call Pertronix yet but thought I would take picture of O ring in pack. Any one know Quote
bambamshere Posted August 18, 2017 Author Report Posted August 18, 2017 Ok so I took truck for good drive tonight. About 20 miles. Everything worked out except idle became a little high at the end when I took it out of gear and it was leaking a bit of oil from either end of the pan. Not sure if I tightened pan tight enough or not. Anyways seems like the electronic ignition is doing it's thing. Quote
Merle Coggins Posted August 18, 2017 Report Posted August 18, 2017 I used to have an issue with my throttle linkage sticking and causing a high idle. I use a little spray lube on all of the connections and friction points and no longer have that problem. Also, you may need to fine tune the carburetor again when it's hot. Quote
bambamshere Posted August 18, 2017 Author Report Posted August 18, 2017 Well the carb was rebuilt. What kind of spray lube did you use? Quote
Merle Coggins Posted August 18, 2017 Report Posted August 18, 2017 I believe what I used, and carry in the truck, is Super Lube. It's a synthetic Teflon lube. I was out of town at a WPC meet when it got so bad that I had to do something. I went looking for a hardware store to find something. I found small store and that's what they had available. I sprayed down the joints and my sticking throttle problem disappeared. I then discovered that my idle was too low when warm and I had to adjust it up a bit. Quote
bambamshere Posted August 18, 2017 Author Report Posted August 18, 2017 Oh ok thank you. Ya idle is to high. Plus you can tell it's a little rich. Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.