bluefoxamazone Posted May 31, 2015 Report Posted May 31, 2015 hello, just filled the old girl up... ( ;-) ) The reading on the gauge shows only 3/4 full. Can this be adjusted or is something more serious going on?... thanks for the advice. greetings from a drizzly Belgium 1 Quote
Plymouthy Adams Posted May 31, 2015 Report Posted May 31, 2015 you will have to trouble shoot a bit more to determine if you have a serious problem or not..could be as simple as a heavy/impregnated float...or could actually be a bad component or simple again as a faulty wiring run/connection.. Quote
cerick305 Posted April 18, 2016 Report Posted April 18, 2016 I have a similar problem, when completely full I get a reading of 3/4 full. When completely empty, I get a reading of 1/4 full. Quote
captden29 Posted April 18, 2016 Report Posted April 18, 2016 mine shows nothing except when getting empty it will bounce back and forth.i finally fixed my odometer so I can go by mileage to know when I need gas. capt. den Quote
mopar_earl Posted April 18, 2016 Report Posted April 18, 2016 (edited) Stops might need adjusted, float arm bent, someone replaced the sending unit using one that doesn't fully match the OE ohms, bad ground to name a few things. Earl Edited April 19, 2016 by mopar_earl 1 Quote
soth122003 Posted April 19, 2016 Report Posted April 19, 2016 Mine reads about 1/2 a tank with key on, and empty with key off. Manual says the #2 post is grounded out. Checked the sending unit with a meter and its reading 0 ohms empty or full. Sucks cause I put in about a year and half ago. Joe Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.