David A.

I used Nylock nuts on mine.

If you’re going to send 6 volts to your coil, you need to be using a 6 volt coil. Otherwise you will have a very weak spark at your plugs. I would think it would be weak enough that it could cause problems running.

If I’m seeing things right, your picture shows you are using a 12 volt coil. So why are you trying to drop your supply voltage down to 6 volts?

I was thinking the B2 three speeds were all synchronized. I know mine is.

I have an 802 in my 50, B2B. It is a tight fit, but it does fit. I installed the radio before I put my soundproofing on the firewall. I had to cut a notch in my firewall cove.

Yes, I used fender welting when I did mine. As ggdad said, it isn’t really needed unless you are going for originality.

My apologies for the wrong information. I looked back through my old paperwork, and it was advertised as being out of a 48 Chrysler. I don’t know why I had it in my head it was a Plymouth. Thanks for catching my mistake!

I too replaced the 4.10 center section in my 50 B2B with a 3.54 out of a 48 Plymouth. As Merle stated the axle spline count changed sometime later, but I’m not sure when. For me it was an easy direct swap.

Looking good! Those bed sides were the hardest part of my truck. It was a very long and tedious process. The worst part is that if you do it right, no one will ever know how much time and effort you have invested in it!!!

Nice looking truck!

Enjoyed the video!

Beautiful!!!

I feel your pain. I spent several months working on my bed sides trying to get them as straight as possible. Mine were also stretched badly and bowed. I tried using heat and jacks but never could get them to straighten out. I finally took them to a custom car shop that had a frame machine. They used that and a torch and got them pretty straight. It still took me a long time to get all the waves and dings out even after that. it just takes a LOT of time and patience.

That’s the same guy selling the NOS valve that appears to be making reproductions. He even shows a moparpro.com add in one of his pictures. That is probably the valve he used to design his reproductions. I guess he wants to get it sold before he puts his reproductions on the market.