Jump to content

Instructions, Manuals & Templates

Instructions sheets, manuals and templates for missing parts.

101 files

  1. Mopar Factory PCV System

    Mopar Factory PCV System how to.

    2,152 downloads

    1 comment

    Updated

  2. OIL FILTER INFORMATION

    OIL FILTER INFORMATION

    883 downloads

    1 comment

    Submitted

  3. Flathead 6 Engine Rebuild.pdf

    Four Part Auto Restorers Magazine article which describes the Flathead 6 teardown and rebuild completed by the author Curt McConnell. 21 pages - pdf format.

    612 downloads

    3 comments

    Submitted

  4. R-10 OD controls, R-10 OD maintenance,R-10 operation

    Factory, training for R-10 Overdrive transmissions
    Shared with me by Jim Yergins (forum member) approx. 2 years ago, thanks again!

    497 downloads

    0 comments

    Updated

  5. Pertronix Electronic Ign. Coverersion Part #'s Per Dist.#

    For those that inquire about this changeover to see if Pertonix makes a conversion to fit their Dist. as installed in their car!
    Year of car/ motor does not make a difference as most can used in many models depending on engine size, BUT I am not adding about differant advance curves, etc of various models.!--Only the Dist. being used! To look at what's avail. Do not want to open that canOworms!
    If/when you locate appropiate # for changeover, I'd suggest googling the Pertronix number and compare prices. Seems to me the last time I was looking , prices where as much as $50.00 variation!
    Doug
    Added more info that I left out before, more distributor #'s for apps.
    Adding several install sheets for 6v. pos. ground pertronix ign. sheets to show most changeover info.
    Thanks,
    Doug

    468 downloads

    0 comments

    Updated

  6. NewP15Service.pdf

    What's new about servicing the new Plymouth P15!

    400 downloads

    1 comment

    Updated

  7. 1947 Owner’s Manual Mopar Radio Model 802 Plymouth Dodge DeSoto Chrysler

    1947 Owner’s Manual Mopar Radio Model 802 Plymouth Dodge DeSoto Chrysler
    Sorry for the upside down scans

    321 downloads

    0 comments

    Submitted

  8. Fuel pump heat shield template

    Dimensioned drawing of fuel pump heat shield.

    240 downloads

    2 comments

    Updated

  9. 1936-1942 Plymouth Service Manual

    This is an abridged service manual covering Plymouth cars from 1936-1942.

    226 downloads

    1 comment

    Submitted

  10. Dash Info

    P15 dashboard controls.

    212 downloads

    0 comments

    Updated

  11. Power Steering.pdf

    Step by step instruction for adding to power steering to a Desoto sedan, authored by Donald J. Smith. Detailed instructions how he modified and added power steering  to his 4 door Desoto sedan. The .zip file contains the individual photos used in the article. 

    211 downloads

    0 comments

    Updated

  12. Chrysler218.236.251Manual.Complete.Reduced_0.pdf

    Service manual for Chrysler Industrial Manuals.

    204 downloads

    0 comments

    Submitted

  13. Borg-Warner OD Solenoid Repair Instruction

    Hope pages are in order, but I'm not into computers, just hope it's a help to someone!
    Doug

    182 downloads

    1 comment

    Updated

  14. Inner Fender to Frame Seal Template

    This template can be used to trace and cut out the masticated rubber seals between the Front, INNER fenders, and the frame.
     
    They are stapled on to each inner fenders ( driver and passenger ).
     
    I was lucky to purchase both inner fenders NOS with the original rubber seals attached. I am sharing them here for your use. I have benefited from help here on other templates so I am paying it forward.
     
    Instructions:
     
    Purchase a sheet / roll of masticated rubber. 1/8 " thick min. ( like tire rubber with poly cord imbedded )
     
    Print the templates on LEGAL size paper ( 8.5 " X 14 ")
     
    Match the two pages where shown and tape the sheets together.
     
    Cut out the template
     
    Trace on to the rubber sheet ( bright color pen / marker )
     
    Cut out the rubber seal.
     
    I used heavy gauge stainless steel wire to make the " staples " and wired the seals to the inner fenders.
     
    Note: my D24 is a Club Coupe, I believe the front fenders are the same on other Models and maybe Chysler's other lines.
     
    Good Luck !
     
    Clay Janer
     
    Conn47D24

    173 downloads

    0 comments

    Updated

  15. SHIFTRITE PAGE 1a.jpg

    Manufacturers installation brochure for the Shift Rite column mounted overdrive control.

    154 downloads

    0 comments

    Updated

  16. Heater Model 504 Installation Instructions.pdf

    Factory installation instructions for Fresh Air heater for B Series trucks.

    149 downloads

    0 comments

    Submitted

  17. Edmunds Install Instructions.jpg

    Edmunds Install Instructions for Chrysler, DeSoto, Dodge and Plymouth 6 Dual Intake Manifold

    143 downloads

    0 comments

    Updated

  18. pilothouse_reflooring.pdf

    Instructions to refloor your B series bed

    142 downloads

    0 comments

    Submitted

  19. 1948-1949 Dodge Truck Drivers Manual PDF

    60 Page Downloadable PDF Drivers Manual for the 1948-1949 Dodge "Job Rated" Trucks.
    Series B-1-B and B-1-C
    These were very detailed manuals and can be very useful in keeping your Pilothouse on the road.
    Buy more online at www.vintagemoparts.com

    141 downloads

    1 comment

    Updated

  20. Fulton Sun Visor.pdf

    Comprehensive Data and Directions for Assembling, Painting and Installing FULTON SUN SHIELD

    139 downloads

    0 comments

    Updated

  21. clutchboot.pdf

    Template for leather clutch boot on passenger cars.

    134 downloads

    0 comments

    Submitted

  22. MoPar Oil Filter Installation Instructions

    MoPar Micronic Oil Filter Element Installation Instructions
    Model Application:
    Plymouth 1934-42 – All Models
    Plymouth Commercial 1937-41 – All Models
    Dodge 1934-42 – All Models
    DeSoto 1934-42 – All Models
    Chrysler Six 1934-42 – All Models
    Chrysler Eight 1940-42 – All Models
    Dodge Truck 1934-45 – All Models Except Diesel & 3 Ton

    MoPar Micronic Oil filter element 861032 can be used to replace other make elements as listed below:
    Purlator PN-15
    Purolator N-15
    AC C-301
    AC C-29
    Fram C-130
    Walker RC-23
    Wix PC-80N
    DeLuxe C-64P

    134 downloads

    0 comments

    Submitted

  23. All Weather Heater Brochure

    An operators guide to Mopar Heatrs

    132 downloads

    0 comments

    Updated

  24. Trouble Shooting in the Transmission.pdf

    3 speed manual transmission trouble shooting guide, Mopar factory service reference book.  

    129 downloads

    0 comments

    Submitted

  25. Vacuum gauge chart

    A basic chart that gives typical readings for trouble shooting.

    120 downloads

    0 comments

    Updated




×
×
  • Create New...

Important Information

We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue.

Terms of Use