uncleaud Posted November 22, 2023 Report Share Posted November 22, 2023 I've been enjoying the fall weather cruising in the 47 Saratoga. Been using it as the daily driver and sorting out little bugs. Everything works smoothly and I have been impressed with how it holds its own in traffic. However occasionally when I lift my foot and wait for the famous clicky clack it fails to upshift and at times when I come to a stop it fails to downshift. The next time it works as it should. I understand the parts the solenoid and the governor play. It appears that the governor isn't doing its part on a regular basis. I have the idle slowed down as far as I can and keep it running. Is there something else that would make the governor sluggish or sticking. Thanks. Quote Link to comment Share on other sites More sharing options...
Dodgeb4ya Posted November 22, 2023 Report Share Posted November 22, 2023 Clean the governor points carefully. No files or sandpaper. Electrical contact cleaner and a lint free cloth. 2 Quote Link to comment Share on other sites More sharing options...
Doug&Deb Posted November 22, 2023 Report Share Posted November 22, 2023 I agree with cleaning the points. Also check the oil level in the transmission. Check the Imperial club website. They have a troubleshooting manual available for download. 2 Quote Link to comment Share on other sites More sharing options...
Tom Skinner Posted November 23, 2023 Report Share Posted November 23, 2023 As always - I agree with all the above repair suggestions, however, the easiest quickest check is: The Fuse check (30Amp) at the Transmission Solenoid. If it isn't working well - and it only takes a minute to check it. Good Luck! Quote Link to comment Share on other sites More sharing options...
Dodgeb4ya Posted November 23, 2023 Report Share Posted November 23, 2023 No fuse (blown) the trans will always imediately upshift and never downshift till complete dead stop. Quote Link to comment Share on other sites More sharing options...
junkers72 Posted November 24, 2023 Report Share Posted November 24, 2023 Also, make sure your idle speed is adjusted to proper spec and your throttle linkage is working freely. Ran into a similar issue recently while driving my 47 DeSoto . Found the screw to be loose where the linkage arm goes onto the throttle shaft . Just sharing my issue . BTW I rewired my car in 2021 due to many wires under the hood to have cloth covering worn off . The more I looked the more I couldn’t believe anything worked at all. Happy Thanksgiving Quote Link to comment Share on other sites More sharing options...
Doug&Deb Posted November 25, 2023 Report Share Posted November 25, 2023 Bad wiring was the cause of my problems with my Gyromatic. A new transmission harness from YNZ Wiring fixed it. Idle speed should be between 450-500. 475 works good for me. Again the troubleshooting manual will walk you through the steps to diagnose the problem. Be aware that you won’t get the trans to up shift while on jack stands which is one of the steps in the manual. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.