Jamie Anderson Posted January 11, 2020 Report Posted January 11, 2020 Could someone please explain how to decode the numbers on the engine block Quote
Plymouthy Adams Posted January 11, 2020 Report Posted January 11, 2020 various numbers, some identify the series and serial number. others are casting numbers...perhaps you wish to ask of a specific number? Quote
Jamie Anderson Posted January 12, 2020 Author Report Posted January 12, 2020 2 hours ago, Plymouthy Adams said: various numbers, some identify the series and serial number. others are casting numbers...perhaps you wish to ask of a specific number? D39-202543 Quote
Jamie Anderson Posted January 12, 2020 Author Report Posted January 12, 2020 2 hours ago, Plymouthy Adams said: various numbers, some identify the series and serial number. others are casting numbers...perhaps you wish to ask of a specific number? Found the ranco valve thank you again Quote
Plymouthy Adams Posted January 12, 2020 Report Posted January 12, 2020 D is Dodge, series is 39 and my book does not show this model and likely a Canadian model number, 202543 is the engine serial number... Quote
Plymouthy Adams Posted January 12, 2020 Report Posted January 12, 2020 4 minutes ago, Jamie Anderson said: Found the ranco valve thank you again glad you were able to locate this....the book does not go into great details on some of this stuff but the heater hose routing from the engine, to the valve, on to the heater core and out/back to the pump inlet is clearly shown. Quote
Jamie Anderson Posted January 12, 2020 Author Report Posted January 12, 2020 9 minutes ago, Plymouthy Adams said: glad you were able to locate this....the book does not go into great details on some of this stuff but the heater hose routing from the engine, to the valve, on to the heater core and out/back to the pump inlet is clearly shown. I need a service manual I have a spark issue I can't figure out some plugs are getting good fire and some are not causing the engine to load up at idle ? Quote
Jamie Anderson Posted January 12, 2020 Author Report Posted January 12, 2020 Just now, Jamie Anderson said: I need a service manual I have a spark issue I can't figure out some plugs are getting good fire and some are not causing the engine to load up at idle ? I have replaced points condinser rotor and cap and wires Quote
Sniper Posted January 12, 2020 Report Posted January 12, 2020 Make sure you double check the plug wire connections on each end. Sometime they like to pop off if you don't "burp" them during installation. You essentially squeeze/pinch the boot to release any trapped air as you are installing he wires. Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.