Plymouthy Adams Posted February 2 Report Posted February 2 (edited) These are spacers needed for the aftermarket wheels I wish to run.....they are hub centric....HOWEVER they are not correct for the Dodge I own. Sources online call it one size and it way small, another is close but not correct and the forum, forget about it, they off also but at least they were aware the hub are way larger. Anyway I ordered these with the expressed intent to chuck into my lathe and open the registers hole to the size needed. Good to have this task behind me and the lathe and shop floor cleaned up. It was a mess after doing the turning. But, I had fun....! Edited February 2 by Plymouthy Adams Quote
Plymouthy Adams Posted February 2 Author Report Posted February 2 good point.....lol One guy was real close reporting the register size....he missed it by 1mm which could well have been a typo...but even if a typo, still wrong. By the way, I measured 3 vehicles....to eliminate the fact mine could have been a fluke. Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.