Found yesterday.

[Jj1981]

Not sure of the year but was wondering how it was covered 

[ggdad1951]

looks like a B3 or B4 visor from the mount design.  They were wrapped in a cardboard/vinyl and edge wrapped.

[Jj1981]

Awesome here’s the truck I got it from

[squirebill]

Based on the doors on the truck with the crease running from the top of the fender line then back to the rear edge of the door, it's a B1 or B2 series.  I needed doors like these for my B1B but could only find B3/B4 doors at the time. The B3/B4 doors have more of a scoop (than a crease ) that goes about half way across the width of the door.  Not sure about the visors.  According to my parts book the B1/B2 visor was a different part number than the visor for the B3 and even another different part number for the B4. Hard to tell what a previous owner may have found and installed on "their" truck over the years.   My truck has an "I" title.  In PA the first owner has an "A" title, then the second has a "B" and so on.  So I am the 9th owner of the truck and there is no telling what the previous owners had done to it to keep it running but fun finding out. Regards.

[ggdad1951]

Stainless under the nose of the hood also confirm B1 or B2

[minicooper]

Nice find. The driver's side visor on my B3 looks the same as that passenger side version, and in identical condition. I was going to attempt to recover it myself, at some point.

 

-Roland

 

[minicooper]

My mistake, that is a driver's side. ?

[Jj1981]

I redid my seat cover by hand so I’ll try to redo it myself

[squirebill]

Would like to hear more about how you did your seat cover.  Mine needs to be redone.  Have a piece of material but that is as far as I have gone.

[Jj1981]

I added foam and sewed the edges and the sides