alsfarms Posted November 23, 2017 Author Report Posted November 23, 2017 Walt, I hadn't thought of a separate hydraulic system to support the steering. I'll bet that is what is is. The main hydraulic pump is mounted on the other side of the engine and is what I guess to be gear driven. That way, if the main pump has some kind of problem, you would still be able to steer, maybe the brakes would also be involved with the smaller pump. Al Quote
DJ194950 Posted November 23, 2017 Report Posted November 23, 2017 On the big rough terrain type forklifts we had back in late 60's and 70's that was indeed the power steer pump that a very small flow pump compared to pump for the lift,tilt, side shift which ran a large GPM and about 2500 lbs. pressure for operation. DJ Quote
alsfarms Posted November 23, 2017 Author Report Posted November 23, 2017 Thanks for the confirmation. After some power of suggestion and a bit of deductive reasoning, it does make good sense to keep the two hydraulic systems separate for safety reasons. Al Quote
alsfarms Posted December 5, 2017 Author Report Posted December 5, 2017 I will post a picture or two of the engine serial number. Can anyone here help me to determine the exact age of this engine based on the serial number or do I need to look for a date code such as GM used to date a casting? Al Quote
alsfarms Posted December 5, 2017 Author Report Posted December 5, 2017 The number appears to be: IND265 630 8130 Al Quote
alsfarms Posted December 5, 2017 Author Report Posted December 5, 2017 Does anyone here have need of the SAE bell housing this engine has? I can measure and determine the exact size. I have also resolved the original question posted in this forum and do have a correct passenger car bell-housing to use for my installation. I just need to locate an 8 hole flywheel or modify a 4 hole to mate to this engine. Al Quote
Don Coatney Posted December 5, 2017 Report Posted December 5, 2017 If you are not using a fluid drive a 4 bolt flywheel will mount to an 8 hole crankshaft. If doing so I do recommend using a bolt with a long shoulder such as pictured below. Also there may be a problem with the starter gear to flywheel measurements. Quote
greg g Posted December 6, 2017 Report Posted December 6, 2017 What is the engine number from the one in your car? Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.