1951 B3B 1/2 ton - need rubber bushing for shifting linkage

[Jim Gaspard]

Been to Bernbaum and Steele without success looking for the rubber bushing/grommet the fits into the shifting linkage rod next to steering knuckle.  Anyone have a source?

[Don Coatney]

I don't have one but is this what you need?

[Desotodav]

Did you look at a T-200 at Bernbaums Jim? I think that is what I ordered - I won't be home until next week to check.

 

[Jim Gaspard]

Thanks all.  I did find on at Bernbaum....Moparparts.   Jim

[pflaming]

A small ball bearing, works great, shifts very easy, a bit out of the box, but oh well. 

 

[johnsartain]

That looks very similar to the rubber grommet/bushing that is used on the shift linkage of the Dodge, Durango/Dakota/Ram X500 four wheel drive shift linkage. Dimensions would confirm this. The bushing I am speaking of is about a 1/2 - 5/8 hole in the shift lever and is designed to fit a 5/16 or so linkage shaft. I have a transfer case out of a truck I can look at this evening if you need me to. I am only guessing at the dimensions.

Edited October 17, 2017 by johnsartain

[Jj1981]

This is what I used works great with a cotter pin to hold it in place. I drilled the center out to fit 

[Jim Gaspard]

I found one on Bernbaum. Thanks guys!