John Burke Posted January 19, 2007 Report Share Posted January 19, 2007 I am replacing the rocker panel trim on the 49 Dodge I am working on. I have no idea how to remonve the old and mount the new. Does anyone have the correct procedure for this job? Thanxz,,,,john B. Quote Link to comment Share on other sites More sharing options...
thedahmer Posted January 19, 2007 Report Share Posted January 19, 2007 rip the old off and throw it away- I believe it just "snaps" on similar to the 46-48- there is no stud clips on them I believe- if you tear it up I have more of them for ya- GD Quote Link to comment Share on other sites More sharing options...
Plymouthy Adams Posted January 19, 2007 Report Share Posted January 19, 2007 They are bolted each end..the ones in the middle you push up on from the bottom and snap the trim off the clip at the top edge...be sure it is unbolted so you can get the flex you need to walk the trim off... Quote Link to comment Share on other sites More sharing options...
thedahmer Posted January 19, 2007 Report Share Posted January 19, 2007 That is why Tim is a GURU!!! Quote Link to comment Share on other sites More sharing options...
greg g Posted January 19, 2007 Report Share Posted January 19, 2007 Sure it's not down on the top and out at the bottom??? That's how I remember on teh P15. But each end is bolted. Quote Link to comment Share on other sites More sharing options...
Plymouthy Adams Posted January 19, 2007 Report Share Posted January 19, 2007 guess it could go either way..the clip extends below the rocker...I pushed up at the clip figuring the spring in the clip would allow slack so it would pop off at the top..either way..go slow and protect that trim... Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.