I Need A Favor From Someone With The Plymouth Ship Baby Moons

[Smokeybear]

Can someone take some good pictures with measurements for me, I need:

1. The inside diameter of the mounting surface

2. The hight of the inner lip (basically if it is laid on a flat surface, how tall it would stand to the outer edge of the cap)

3. The outside diameter of the whole cap

 

Thanks in advance to whomever can do this for me.

[Robert Horne]

What year caps you dealing with?

[greg g]

Deluxe or Special Deluxe??  I understand they are different.

[Smokeybear]

I'm trying to figure out how to post pictures from photobucket  but the forum is not letting me. Anyway I may have to post these one at a time. Here is the wheel I have.

[Smokeybear]

Here is the cap I have. it is a plain jane cap that is 7.5 inches ID but it sits about 3/8 to far out from the wheel.

[Smokeybear]

Here you can see how big the lip is.

[Smokeybear]

What I want is the plymouth ship caps because I'm cutting the center out of the two rear wheels to widen them to 8 inches but I want the "stock" look. Here's the cap I want but I'd settle for the cap with the "Plymouth" letters too.

 

 

[Alshere59]

Can someone take some good pictures with measurements for me, I need:

1. The inside diameter of the mounting surface

2. The hight of the inner lip (basically if it is laid on a flat surface, how tall it would stand to the outer edge of the cap)

3. The outside diameter of the whole cap

 

Thanks in advance to whomever can do this for me.

The ship is different but the size should be the same. This fits a 15 inch rim. I have tried on 3 styles of dog dish caps they all fit the same wheel though. Not saying there isn't something else out there.

 

1. 7 1/4" 

2. 13/32"

3. 9" (It looks less but it is 9" on the nose.)

 

Also the profile from the inner measurement to the outside diameter is offset. Say 3/8's from the outside is flat (slightly concave to the inside of cap.) to a 70 degree angle for the remainder of the inner dimension.

I have four all painted a bit different to see how they look.

 

 

[Smokeybear]

The ship is different but the size should be the same. This fits a 15 inch rim. I have tried on 3 styles of dog dish caps they all fit the same wheel though. Not saying there isn't something else out there.

 

1. 7 1/4" 

2. 13/32"

3. 9" (It looks less but it is 9" on the nose.)

 

Also the profile from the inner measurement to the outside diameter is offset. Say 3/8's from the outside is flat (slightly concave to the inside of cap.) to a 70 degree angle for the remainder of the inner dimension.

I have four all painted a bit different to see how they look.

 

 

design.jpginside.jpgedge.jpgtotal.jpg

Thank you, that is exactly what I needed. As you can probably tell, the ones I have would stand proud of the wheel a lot more than the correct cap. Thanks again.