50mopartruck Posted June 8, 2012 Report Posted June 8, 2012 I bought a 1950 Dodge 1/2 ton truck and I would like to change out the drivetrain , right now its a flathead six, I want to put a small block mopar in ti(318,360) anyone make a motor mount kit for doing this? Quote
bach4660 Posted June 9, 2012 Report Posted June 9, 2012 take a look at dan's posts on his hemi http://www430.pair.com/p15d24/mopar_forum/showthread.php?t=20635 Quote
tomkats48 Posted June 30, 2012 Report Posted June 30, 2012 I have a 48 Plymouth 5 pass coupe that I picked up recently minus the engine and transmission.At the moment I'm rebuilding the stock suspension I'm almost complete with that.But had come across a complete 360 engine and 904 transmission.I was wondering if anyone has installed this set-up in a coupe and how much modifying is required if any.Also what would be a good rear-end to use with this set-up any suggestions will help thanks Thomas. Quote
Jonnyz72 Posted July 2, 2012 Report Posted July 2, 2012 I have my 318 & 904 installed in my 47 Desoto. I'm using the stock steering & suspension. You can email me to find out what I've done. jonzavrel@yahoo.com Quote
Kirby D34 Posted July 3, 2012 Report Posted July 3, 2012 I have a 318 and 904 in a 1950 Dodge club coupe. i used a 8 3/4 rear end out of a 1966 plymouth B-body Kirby D34 Quote
Plymouthy Adams Posted July 3, 2012 Report Posted July 3, 2012 I think the question was about installing in a truck... motor mounts are easy to make.. Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.