oldodge41 Posted October 29, 2011 Report Posted October 29, 2011 We bought three forklift motors from a warehouse that was closing. Two were just like our car versions but one had sleeved cylinders. Two had the same size intake and exhaust valves and one did not. The one with sleeves went in a '59 dodge truck that we sold and one of the other two went in a '49 Dodge cpe. that was also sold. The other one was just a block as I remember and is stashed away somewhere in the back of dad's garage I think. Quote
TimMuldoon Posted September 10, 2020 Report Posted September 10, 2020 The Plymouth motor in 1938 that was made in Canada was a 218. They decided to make only one motor for economic reasons. they could not support making a 201 and a 218. They went with a 218 25" because they could use that block for a larger variety of engine offerings. I have not confirmed it yet but the 218 in Canada did not get up to production until January 2018. that means the USA sent 218 truck motors to Canada to augment P6 production until there 218 line was up and running in January 2018. I have a early 38 P6 Deluxe coupe with a 218 truck motor which was made in Windsor. I need to find a similar production run Car that has a 218 truck motor built in it before January 1938 to confirm. From what I read all Canadian motors were 218 at least at the start of production in 1938. FYI my car has a block heater. my engine number is T584753. The casting numbers are 10-13 and 666029-2. It was the 496 P^ made off the line and if 10-13 is what I think it is then the motor was made in the USA on 10-13 -37 and shipped to Windsor to be installed in my car. Quote
Sniper Posted September 10, 2020 Report Posted September 10, 2020 You realize this is an almost 10 year old thread? 1 Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.