P-15 Back Seat Installation

[kbuhagiar]

Hello Folks,

On the P-15 Club Coupe, how does the back seat bottom cushion stay in place?

On my car, there are two metal tangs that stick out from the floor. It appears as if they are supposed to hold back against corresponding parts of the seat frame. However, when installed there is no tension between the cushion and the tangs, allowing the seat to move front to back.

Any ideas? Can the tangs or the seat frame be bent forward or back to provide the necessary interference fit?

Thanks in advance.

[Young Ed]

Look at the bottom of the seat frame there should be a slot that each of those metal tangs goes into.

[kbuhagiar]

Look at the bottom of the seat frame there should be a slot that each of those metal tangs goes into.

Thanks Ed, I'll take a look.

[Eneto-55]

I'm going on REALLY long term memory, but I am thinking that those tab-hooks in the floor hook against part of the wire frame under the seat. If you are test fitting the bottom seat cushion without the back cushion in place, then it would seem loose, as the bottom cushion presses against the back.