fedoragent Posted July 26, 2010 Report Share Posted July 26, 2010 Folks, On another thread, someone suggested I somehow move to protect the rubber fuel line so that it doesn't get melted by the exhaust. I must be retarded or something because I can't think of a good way to keep the line cleared so that there isn't a safety problem. Does anyone have a suggestion? Thanks, FG. Quote Link to comment Share on other sites More sharing options...
aero3113 Posted July 26, 2010 Report Share Posted July 26, 2010 I think it should be fine, the exhaust is not as hot at the rear of the car. You can maybe put some fuel resistant sealant on the ends of the hose by the clamps just in case if it decides to leak. Quote Link to comment Share on other sites More sharing options...
Niel Hoback Posted July 26, 2010 Report Share Posted July 26, 2010 Those wires look a little too close for comfort also. Could you just replace the rubber section with metal from the tank up to the end of the line at the top of the rubber section? Then just use a 2" piece to connect the two metal lines. Quote Link to comment Share on other sites More sharing options...
greg g Posted July 26, 2010 Report Share Posted July 26, 2010 Why is the pipe routed under the tank?? I might want to address the exhaust locatioin then go after the gas line and wires. Quote Link to comment Share on other sites More sharing options...
BobT-47P15 Posted July 26, 2010 Report Share Posted July 26, 2010 I think on a P15 there is room (just barely) to run the driver's side pipe between the end of the gas tank and the spring. It does mean the tailpipes are farther outboard than these probably are. Pic of a P15 convert with pipe outside gas tank.......... Quote Link to comment Share on other sites More sharing options...
Oldguy48 Posted July 26, 2010 Report Share Posted July 26, 2010 Maybe some "exhaust wrap" as mentioned in another recent post would be a possibility. Quote Link to comment Share on other sites More sharing options...
fedoragent Posted July 28, 2010 Author Report Share Posted July 28, 2010 Folks, I measured today the length between the exhaust and the fuel line. It is 10 inches away. I'm good there. And the wires are 7 inches away from the exhaust so I think I should be good there as well. FG. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.