randygall Posted May 31, 2010 Report Share Posted May 31, 2010 Can anyone show me the routing for the cables from the battery to the starter?. I seem to have mine routed the wrong way, The clutch pedal is hitting it. Quote Link to comment Share on other sites More sharing options...
JoelOkie Posted May 31, 2010 Report Share Posted May 31, 2010 Can anyone show me the routing for the cables from the battery to the starter?. I seem to have mine routed the wrong way, The clutch pedal is hitting it. I can't help you, as I made a battery box under the hood, but that old cable that was on the truck when I got it was ran through a piece of old garden hose, I am guessing to keep it out of the way. Joel Quote Link to comment Share on other sites More sharing options...
jakenoklahoma Posted May 31, 2010 Report Share Posted May 31, 2010 My ground cable goes from the battery box area straight to my transmission. I'll have to look at the negative cable to see its routing, but its raining right now... Quote Link to comment Share on other sites More sharing options...
Merle Coggins Posted May 31, 2010 Report Share Posted May 31, 2010 Here is my original cable laying in pretty much it's original position. I later replaced it with a new one and routed it the same way. It lays on top of the frame and is clamped down with a couple of clamps along the way. Here you can see my new cable on the left edge of the picture. It's clamped down with the original clamps. Here again you can see how it loops in from the frame to the starter. It won't interfere with anything if you route it that way. Merle Quote Link to comment Share on other sites More sharing options...
JBNeal Posted May 31, 2010 Report Share Posted May 31, 2010 (edited) My '48 had a shorter cable than MC's, and judging from the bite marks from innumerable jump starts I reckon it was the original cable. I salvaged a set of cables from Dad's 1206 Farmall after a JD mechanic used an air ratchet to tighten the cable terminals and split the ears off. With new terminals, I routed the cables from the battery towards the transmission, then made the left turn behind the brake pedal for the starter. The lug on the starter is bent to allow the cable to be snug up against the switch as shown. Yeah, the cable sorta hangs in mid-air, but I'll remedy that when I tear the truck down to make it purty here shortly. On a side note, after the '48 sat in the garage for the last 9 months, I fired it up & backed it out a couple of days ago and took this pic this morning. I had left the battery connected and didn't top charge it, and the untreated gas is almost a year old. Ten seconds cranking on the starter, three pumps of the throttle, and it fired right up...no smoke, no farts, just a smooth idle and some drips out of the timing cover & rear main seals that I need to replace. Another testament that the factory 6V system is adequate for these old trucks as long as everything is in good working order and electrical resistance (i.e. corrosion) is held at a bare minimum. Edited June 8, 2018 by JBNeal restored picture Quote Link to comment Share on other sites More sharing options...
randygall Posted June 2, 2010 Author Report Share Posted June 2, 2010 Thanks for the help. 1 Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.