Carb Spacers to turn carbs 45 degrees..

[mackster]

I got my dual carb set up for my desoto 25" block flat six. I need to turn the carbs 45 degrees as the carbs linkage face front to back and I need them to face side to die so I can use my existing linkage. Can you help? where can I get some spacers on line? I'm running single barrels carter B & B. thanks Mack G.

[48mirage]

I had a little different setup. I mounted a holley 94, 90 degrees from the normal position so that I could use my original linkage. The way I did it was took a bottom gasket and a top gasket to the local machinist and had him mill a piece of aluminum to make the fit. My set up was a little more difficult but I'll bet you could get a couple cut for around $60-70.

[mackster]

I was told before to get the adapters from stovebolt or vintage speed. I looked for this today and found none. Any other suppliers?

[greg g]

If you call them, they will probably have them. I think they only show the 2 to 1 adapter in the on line catalog.

[mackster]

Thanks Greg I will try that tomorrow. Hope they have them available...