Crankshaft pulley

[Mertz]

The crankshaft pulley that came with the industrial engine I put in the truck has a hub and pulley that bolts to the hub. The pulley is cast. This pulley however does not line up with the water pump or generator pulleys. The original pulley is stamped and has timing marks (the cast one doesn’t) but the stamped pulley has grooves from wear. I can’t find a reasonably priced pulley for my truck. There is a sleeve that can be added to the old one to cover the grooves costing $68. I would rather find a new pulley. Is there a correct pulley that will bolt to the hub I have that will align with the other pulleys? Does anyone have the correct pulley they are will to sell?

[kencombs]

I think I read that you have good cast pulley with a seperate hub.  But that combo doesn't match the other pulleys alignment>

 

And, you have a one piece pulley and hub that has grooves in the hub part.

 

Do you have a pic to the original?   Posting it would help.

 

And to follow the site rules, the parts request should be in the 'parts wanted' area I think.

[Mertz]

You are correct. I will post a request in parts wanted.  
I will check to see if the pulley goes in far enough to miss the groove because it is near the end.  Probably not lucky enough for that but it is going into an industrial engine so it might make a difference.