windup windows a problem

[casper50]

I trial fit my garnish molding and vent windows in my doors yesterday.  Neither is working very well.   When completely in the down position and begin the rollup the front catchs on the bottom of the vent window.  After prying it so that it clears it winds up well until the last 1/2".  Then the back of the window is lower than the front.  Both sides.  Could the new fuzzies and welting be hindering free rise?

[DJ194950]

Have you tried adjusting the window lower stop to set the all way down position?

The window front to back angle is also adjustable on the window mechanisms front and rear at their mounting points.

This all assumes that the window mechanism rollers and such are in good condition?

Your on the downhill part of this project!

Summer and cruisin' are getting close!

DJ

[Tom Skinner]

There is in the middle of the door a large nut, in which the Regulator/Armature mechanism may be adjusted to correct this situation.

There was a recent thread on installing front glass that touched on this. The Manual simply shows it as an adjustment nut. Try it.

It will correct this problem. Of course one must remove the Fabric Panel to see it. Also check to see if the Window is in its track right with snap rings in proper place.

Tom