randygall Posted September 12, 2010 Report Share Posted September 12, 2010 does anyone have a picture of what one should look like? Quote Link to comment Share on other sites More sharing options...
suntennis Posted September 12, 2010 Report Share Posted September 12, 2010 There are some photos of a heat shield on page 2 of this forum under the title Potential Vapor Lock from Woodie49 and a date of 9-9-2010. You have to go thru lots of comments until you get to one by Woody49 dated 8-20-2010 at time 7:41 AM. There are three photos. You can buy these shields from a guy in California for around $40.00 or make one. Quote Link to comment Share on other sites More sharing options...
greg g Posted September 12, 2010 Report Share Posted September 12, 2010 (edited) I believe in the downloadable material linked from the main page of the site that hosts this forum is a printable measured drawing for making one from sheet metal. Actually checking there it is not there but here is a picture of one that was found in the technical tips section I would encourage everyone who uses this forum to push the button at the top of the page that says "Return to P15-D24" and spend some time reviewing the important and informative material there that our gracious host spent time compilling and assembling, and organizing there. Not yelling at folks but there are answere to a lot of frewuently asked questions. Edited September 12, 2010 by greg g Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.