throw out bearing spring

[chucky07]

excuse if i sound like i've never done this before..but i haven't

I'm installing my transmission....I got the pressure plate and clutch disc aligned (kinda) and bolted up loosely..then I went to install throw out bearing...i guess it just sits on the two arms in the rear.? there is a spring but I cannot remember where it is suppose to hook to? Also I have a new throw out bearing but cannot figure out how to get old one off sleeve?

any help would be appreciated ( i'm trying to use my old manual but cannot figure this out from pictures)

thx

[Merle Coggins]

The bearing needs to be pressed off of the sleeve and the new one pressed back on.

The spring connects between the throwout bearing and a pin that points in toward the clutch at the upper inside of the transmission pilot hole.

Merle

[chucky07]

thank you..i saw the screw up top ...i thought it might be..but wanted to make sure..my manual isnt clear on it..and i forgot..since it's been 10 months

guess i'll take bearing to machine shop...if im lucky i'll get it back in a month or two..(small one horse town in the middle of no where)

[streamer]

I just changed my throw out bearing and I was able to simply tap it off with a light hammer. Give it a try.