Woodie Posted April 28, 2022 Report Posted April 28, 2022 does anyone have an extra used one of this tab I circled - this stays in the collar when shifting to reverse? It is a hardened part and just one bolt on the steering column holds it.. My car keeps not going into reverse and I am afraid if I remove it and try and bend it it may break as it is probably hardened steel ( I squeezed it with vice grip into collar but just sprung back) The part is supposed to be in the collar (down where the yellow dot is) but slips out when trying to shift to reverse. Quote
Woodie Posted April 28, 2022 Author Report Posted April 28, 2022 Forgot to say for 48 Chrysler New Yorker Quote
Dodgeb4ya Posted April 28, 2022 Report Posted April 28, 2022 (edited) The pivot pin this lever is on might be bent not the lever..but if necessary take it off the car put it in a vise and slightly bend it slightly using a dead blow hammer. Bend and fit to the car as necessary It will not break.... First figure out what actually is bent. Edited April 28, 2022 by Dodgeb4ya 1 Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.