woodjunky Posted June 25, 2016 Report Posted June 25, 2016 I am going to fabricate a stainless steel block off plate to go beteween the intake and exhaust manifold. My question is, should the plate fit into the the square opening ? Or large enough to have to drill the four 5/16" holes ? Quote
Jerry Roberts Posted June 25, 2016 Report Posted June 25, 2016 It would be a lot easier if the heat shield doesn't fit between the two manifolds . It can sometimes be a very big job to loosen and separate the manifolds with possible bolts breaking off . My home made heat shield is just held in place with a piece of wire . It looks and works fine . Quote
Jeff Balazs Posted June 25, 2016 Report Posted June 25, 2016 Jerry I believe he is talking about eliminating the heat riser and putting this in it's place. I did this and I made the block off plate full size with the holes for the 4 bolts. Jeff Quote
woodjunky Posted June 25, 2016 Author Report Posted June 25, 2016 Jerry, Jeff is correct. I have already seperated the two. A couple days of PB Blaster, and the Turbo Torch and all four came out without snapping Imagine that. Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.