ggdad1951 Posted June 5, 2013 Report Posted June 5, 2013 So I've finally gotten around to pulling my roll-downs so I can get them seated properly in the regulator since I want to be able to use them!. I also can now also replace the fuzzy for the wing window edge that I hadn't done. What have you guys done? I see 4 semi-tubular rivets, but also some adhesive might be in order? Quote
ggdad1951 Posted June 5, 2013 Author Report Posted June 5, 2013 once taken apart it became obvious one edge is kept under a bend and the rivets just hold it in place...I've answered my own question. Quote
Desotodav Posted June 5, 2013 Report Posted June 5, 2013 I didn't have the rivets holding my 'L-shaped fuzzy' in place Mark - from what I could see the was just glued on to the window divide bar. I used black Sikaflex to glue them in place. I also used it in the bottom of the sliding glass channel as I was not totally convinced that the rubber that I had installed in there would keep a firm enough grip on the glass edge. Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.