Todd B Posted February 10, 2012 Report Posted February 10, 2012 I have the chevy automatic trans installed and my drive shaft is now too long, I have 3" of travel from just being on the spline to completely pushed in. I am not sure were it should be to start. I assume in the middle but we all no what "ASSUME" stands for. Todd B Quote
sniggle_t Posted February 10, 2012 Report Posted February 10, 2012 There should be some wear from the seal so I would start there. Quote
Dave72dt Posted February 11, 2012 Report Posted February 11, 2012 Push the yoke all the way in, then pull it out 1 inch. For measuring, the full weight of the vehicle needs to be on the rear axle. Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.