Jump to content

Recommended Posts

Posted

Yep, one shot oughtta take care of it...I put one shot in slowly while the motor is at idle so the grease will coat the shaft+bushing evenly.

Posted

A trick I learned was to take the zerk out and fill a large syringe with the grease and then inject it where the zerk was. That way you fill the cavity but don't put so much pressure as to blow the seal. I have done this with rear wheel bearing also. Fills the void but doesn't blow the seals.

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...

Important Information

We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue.

Terms of Use