stainless trim

[58prostreet]

I just recieved some stainless trim that I orderd from an outfit called Max Merit Auto. They make stainless for Packards, but it can be used on anything. They offer 1" or 3/4" with pointed tip, offset pointed tip, or squared. Also offer 1/2" in pointed or square. Their site says $10.00 per foot and $10.00 per end, but it is slightly higher than that. I got 4 pieces, 52.5" each ,of 3/4 pointed for $70.00 per piece. Also got 24 fasteners for $24.00.

Shipping was about $30.00. May be a little pricey. but is nice stainless. I was afraid it would not bend to the contour of the fender, but it is going to work fine. Nice people to deal with on phone is a bonus.

www.maxmerrittauto.com

Also as info. If u decide to get any u need to measure distance between front and rear hole and add at least 4 inchs. The crimp for the clips doesn't start til about 1.5 inch in.

Bob

[DJ194950]

Thanks for the link!

Been looking for rear fender moulding for a 50 ply. 4 dr. for the past 1 1/2 years.

Maybe their's could work. Would need to be some what bendable as you suggested theirs was for you.

Added to favorites, maybe at some future date i could afford to order.

Thanks

Doug

[58prostreet]

I should have said mine was for a '52 Dodge Wayfarer. I used the same length for each fender.

Bob