Preperations for transmission rebuild

[tom'sB2B]

I'm working on making notes and lists in preperation on pulling my trans. and having it rebuilt. Its grinding bad in first gear and leaks pretty bad

I have a fluid-drive 3spd.

I know I have to pull my gas tank and cross member before I pull the tranny.

Gaskets needed:

21-29-25

(2X) 21-09-33

(2X) 21-33-17

Oil seal 21-22-2

Im going to create a gasket for between the front of the trans and bell house.

Any input or something I'm missing?

[Guest P15-D24]

There is no first gear syncro, Good trick when going from neutral is shift up to second, then first. Second has a syncro and it stops the input shaft from spinning, then drop into first cleanly. If your ordering a syncro wait until you pull it down as two different types were used. Should also get a small parts kits and pay attention to the correct assembly order for the thrust washers on the countershaft.

[tom'sB2B]

Any ideas on where I can buy transmission gasket and bearing kits?