column shifter bushings-gromments

[Guest walrus947]

Do any of the members know who sells new column shift linkage to selector shaft bushings or groments, I am open to a good used one for the reverse-Low gear columun shift selector. most any late 40's early 50's should work, really need one , thanks ,,,sam

[Guest Kuster13]

Sam,

I have to check but I may have some if not all the linkage you need. Could you post a pic of what you need.

Tom

[Dodgeb4ya]

Try Neil @ seaplym@hotmail.com . He sells on Ebay and has the grommets for the p-15`s. Maybe he has the grommets for the trucks too.

Bob

[Guest walrus947]

Kuster 13 Tom ., I don't have a picture but it is the gromet or bushing on the column shift selecture shaft that connects to the transmission selector shaft, It is located in the engine compartment down on the steering column where the levers come through below the firewall. I would say it is made of rubber and fits in a loop that holds it , a hole in the middle where the end of the transmission selector shaft goes into to attach it . If you look at the steering column in the engine compartment and have someone inside the car move the shift lever between low and reverse you will see it . Please check and see if you have one , I need a new one or good used one, thanks ,,,,Sam

[RHDSP15C]

Frank Mitchell has this part NOS