Search the Community
Showing results for tags 'Installation'.
Found 5 results
-
Version 1.0.0
25 downloads
Source: https://archive.org/details/sim_motor-age_1947-08_66_8/mode/2up -
Installing Chrysler Front Suspension Bushings - from Motor Age August 1947 View File Source: https://archive.org/details/sim_motor-age_1947-08_66_8/mode/2up Submitter JonathanC Submitted 08/15/2022 Category Instructions, Manuals & Templates
-
Help please as I am ready to install the rear glass. 1. Is a sealer still needed? If so what type, silicone, etc 2. The rubber gasket. Do I place the two ends meeting at the top, bottom, side?? Thanks all.
-
Guys, I bought new intake and exhaust manifolds for my D-24. The shop manual only lists the torque spec. There are no directions for installation. Do I bolt the 2 together first( 4 bolts near the carb mount ), or do I bolt them loosely to the engine, then snug the top and bottom halves where the carb mounts, then tighten to the engine finishing the top/bottoms last? Or, do I tighten completely to the block first? I DO NOT want to induce a crack in either piece. Help, please!
-
Help! I've been searching high and low for information on this and was directed to this forum site by Gods Grace I hope someone can help! I have a 47' Plymouth Special Deluxe. I've restored pretty much everything on it. I'll post some pictures later if you are curious! Anyways I am looking for a diagram, or video that shows me how to remove, repair and install the windows, Pictures, walk-throughs, anything that will help me! I would really appreciate it!
