Chiefrocka

Interesting, and thanks guys !

I did notice that in the replacements, #3595 and #3596 ... the bore sizes would be facing the same direction. Again, however on my '53...one side had a 1 3/8" bore...and the other side was staggered. I just didn't pay attention when I disassembled. thanks

Replacements from Napa ....

Hey guys ... So I pulled apart my brakes to find my wheel cylinders where leaking, rusty, full of grime, and completely frozen. I didn't pay attention to the what side they came off. One side had a 1 3/8" x 1 1/4", and the other had a 1 3/8"x 1 3/8" I have the replacements one had, and I ordered an extra of the offset size. I assuming the larger of the two would be on the pass side, because it is further from the master. Anyone know ??

ok, thanks ... How about the front and rear glass...and window channels ?

Hey guys .... where would I go for glass rubber and door weatherstripping ?

Thank you, this will help. Where can one purchase this manual ?

Hey guys... I received this truck in pieces....and trying to figure out sheetmetal mounting, starting at radiator support. Is there a diagram here on the forum ?

Hey guys... I received this truck in pieces....and trying to figure out sheetmetal mounting, starting at radiator support. Is there a diagram here on the forum ?

I thought the MarK stampings of the strips and bed side angle pieces were really good ....

Hey guys... Looking for some help to get the bed back together. I picked up the strips and bolt kit with pads from MarK...and some cheap planks from Lowes. I only have two crossmembers out of the four (?) I'm supposed to have, so I'll have to makeat those. Does anyone else have a diagram, or a link to help me figure this out ?? Thanks !!

I actually just found it ... Looks like what I need is #1362 12v Neg Ground