bts_dodge49 Posted September 2, 2007 Report Posted September 2, 2007 Hello all, would anyone have pictures of where the weather stripping goes around the doors for the 49 Dodge B1B? I took pictures of everything else but that, and I can't for the life of me figure out where the pieces go... Thanks ... Todd Quote
Dennis_MN Posted September 3, 2007 Report Posted September 3, 2007 Went out to snap a couple of pictures but my battery was dead so the flash wouldn't work so I'll wait for an hour and try again. However when I opened the passenger door I noticed that I would need three pictures. 1. one piece is mounted on the cab rear starting just above the running board and extending up and around to about 6 inches down the windshield post. 2. one piece is mounted on the door front edge starting slightly infront of a line drawn up from the back edge of the wing vent and then runs down to a point just past the floor. 3. the third piece is a piece glued on the door panel and runs across just below the floor surface. Dennis Sullivan Monticello,MN Quote
Dennis_MN Posted September 3, 2007 Report Posted September 3, 2007 Two pictures to show the part that is glued to the cab Where it stops on the cab Quote
Dennis_MN Posted September 3, 2007 Report Posted September 3, 2007 Here is three shots of the door... The first shot is the simple piece across the bottom The second is the top of the door and the last trys to show the weatherstrip running down the door Dennis Quote
bts_dodge49 Posted September 4, 2007 Author Report Posted September 4, 2007 Thanks, I appreciate it.... Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.