NobbyofTexas Posted March 18, 2012 Report Posted March 18, 2012 (edited) Can anyone tell me what parts go where on the driver and passenger windows on a 1952 Dodge B series truck? I have the windows, have all new window rubber, have all the stock window rollers, and other mechanics of the windows but CANNOT figure out how to put everything back together. Especially confusing to me is how the division bar between the vent window and the large window is supposed to be installed?????? When I purchased the truck, all the mechanics and windows had already been removed as new glass had to be cut which I have had done, but for the life of me I cannot figure it out. Any advice, photos, anything that would help me get my windows back in the truck would be appreciated. I am just frustrated as hell with my ignornace. Thank you, Gary Miami Texas Edited March 18, 2012 by NobbyofTexas correct spelling Quote
Desotodav Posted March 19, 2012 Report Posted March 19, 2012 Gary: In case you’re wondering about the install process, I found this process worked for me: the 2 inside door 'weatherstrips' (23-63-97) get attached to the door first via 3 small press-in clips each side, then the complete vent window goes in with a few screws into the door channel, and then the 'run' (23-42-16 shown to the left of the manual picture) goes in - it should have a tab to the lower end which it slides into to hold it in place. The complete sliding window with bottom 'channel' (23-09-52) complete with the other 'run' (23-42-16' shown in the centre of the manual picture) and 'division bar' (23-64-6) slides in gently next. The 'channel' (23-09-50) can then be slid in place and secured from inside the door after the sliding glass is inside the door – it should have has 2 bolts down through the vent window channel and 2 bolts around the middle of the inside of the door. The 'regulator' (23-39-5) has a nut which allows a slight adjustment to get the window travelling straight up and down. Try the search function on the topic as I’m sure there was a fair bit of chatter about installing door windows not that long ago. Desotodav Quote
NobbyofTexas Posted March 19, 2012 Author Report Posted March 19, 2012 Desotodav, that was exactly what I was needing, I will follow your instructions and maybe get the windows put back together. Thank you, Gary Miami Texas Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.