LAKOTA169 Posted July 5, 2011 Report Posted July 5, 2011 Just starting to install these on my '37. Just noticed a problem with wiring diagram for the signals. The drawing for wires #3 and #4. Drawing shows #3 as Left Rear and discription says #3 is Left Front. same for #4 except for the right side. Which is correct? For my relay, the diagram show 4 terminals including power and GROUND. The relay I have only has 3 terminals (one for power). I have to run a wire from my dimmer switch to the relay. My problem is I can't get to the dimmer switch (floor mounted). Can't see it from under car. Two mounting screws on floor. If I remember correctly, last summer I had the flat part of the floor out, and couldn't see the switch then. Am I going to have to take the toe board out? Right now, my wiring is = Power to Ammeter to Headlight Switch to Dimmer Switch. Do I disconnect the wire from the HL switch to the dimmer and run that to the relay and run one from the dimmer to the other terminal on the relay? I know the fused terminal on the relay goes to power. Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.