Pinion Sleeve

[Tom Skinner]

I put a Speedy Sleeve on my Pinion Yoke and it stopped Leaking.

Neat little Trick. Just Freeze the Yolk then use a block of wood or the Sleeve tool to bump it on place with some sealer and Presto no more Pinion Seal Leak.

Tom Skinner

Huntersville, NC

I tried this thread as a test to attach apicture so if I messed up please allow me some grace. I might have a picture too large.

[P-12 Tommy]

The picture size is great. Don't ya just love them Speedy Sleeves? The one I put on my pulley hub for the timing chain seal so far has left it dry.

Tom

[aero3113]

The picture size is great. Don't ya just love them Speedy Sleeves? The one I put on my pulley hub for the timing chain seal so far has left it dry.

Tom

Tom,

Do you have the size/part number you used for the sleeve on the front pulley? There is a groove worn on mine and would like to install one.

[Tom Skinner]

Aftera Pinion Seal was installed it still leaked.

I was able to sneak the Yolk off and Speedy Sleeve it withought messing with the Seal again.

Tom

[Tom Skinner]

Note ho wthe Tail Pipe was being sprayed with 90 wt for a short time until I made this repair. By the way I think the Yolk is 1-7/8" diameter. The Sleeve ends up being Slightly smaller and once the Yolk is Frozen it Bumps right on.

It was fun. They are however a little bit proud of Speedy Sleeves $35-$40.

Tom

[P-12 Tommy]

Tom,

Do you have the size/part number you used for the sleeve on the front pulley? There is a groove worn on mine and would like to install one.

Here's the NAPA Part# 99218. I.D. 2.1880 inch.

Tom

[P-12 Tommy]

These pictures should help.

Tom