Search the Community
Showing results for tags 'transmission mounts'.
Found 1 result
-
I am in the middle of fitting my 218/2004R combo into the '52 Suburban and can't quite figure out how I'm going to support the rear engine with mounts. I have a transmission mount with polyurethane pad for the rear tail shaft of the transmission, and I'm using the stock single motor mount for the front, but the stock rear motor mount crossmember needed to be cut out to make room for the auto tranny. I've looked at a number of after-market solutions from Summit, JEGs, Butch's Cool Stuff, and other sites, in addition to Forum threads, but most of the swaps are for SBC or other V8s, and not designed for a GM auto trans with our stock motors and frames. The shiny Wilcap adapter has a number of pre-drilled mounting holes, but I'm not sure if it would be better to have rear engine mounts under the rear of the bell housing, or attached to the Wilcap adapter. Anyone else face this issue?
