Search the Community
Showing results for tags 'distribution tube'.
Found 1 result
-
I've searched motor mounts/engine mounts & came up with a lot of results....most of which only included the words "engine", "mount", etc...anyway, to the problem at hand. I can get at 3 of the 4 nuts for the front mount (rubber sandwiched between the 2 plates). I can't access the front right (passenger side) bottom nut under the front "cross member". The timing chain cover protrudes out & blocks access to the nut. My question is:how do you access the nut? Do I need to remove the 2 top nuts (done) & lift the engine enough to unbolt the cross member/remove from the car & then remove the engine mount from the cross member? I plan on also replacing the rear mounts. E-brake cable will be addressed (running over trans cross member). Pics included for "WOW" factor, along with pics of the "garage made" distribution tube I pulled out, which will be replaced, along with the rebuilt water pump. (1938 Plymouth P6 Coupe) front rear drivers side-upper rear drivers side-lower rear passenger side-upper rear passenger side-lower