ssdave
-
Posts
29 -
Joined
-
Last visited
Everything posted by ssdave
-
Thanks for the replies. I do have a manual, but like others have said, the part numbers don't always cross reference to todays parts. I even called Atwater-Kent to verify the info I had. Just thought I would ask the experts before making yet another mistake.
-
Need a fuel sender for 1947 Chrysler 8 cylinder. Have searched and called people but still don't get a definitive answer. Are they different for a 6 cylinder? Bernbaum says length of arm is different, others say they are the same, yet listings at Roberts and Bernbaum only say "6 cylinder". Can anyone help?
-
Thank you very much!
-
Kind of an obscure question, but here goes anyway. Rewiring a 47 Chrysler and there's a brown wire that goes from the generator to starter solenoid. Anyone know it's purpose?
-
Read more
Hi Mark, Am doing a 12 volt conversion on a 47 Chrysler and have most things covered. Read your post on a 12 volt horn relay. Anything special? Where did you purchase one? Thanks for any help. Dave
-
Don't know how to post a picture, but It's on ebay. Ben's Auto Parts (benher58) 17" long, 3 1/2" coil length. $5.96 free shipping
-
Found a "universal" one with the right amount of coils and length, just have to make my own loop on one end. $6 I can make my own loop for $64 !
-
$70 for a spring. They sure aren't bashful!
-
That's the one!
-
Finally got the picture to load. Yes, the spring I need is very similar to that. 10" long, coil area a bit shorter. "Clutch pedal pullback spring"
-
Thanks for the reply Don, but for whatever reason I can't open the link
-
This is for a 47 Chrysler New Yorker. Have looked everywhere, including extension spring manufacturers with no luck. 10" long spring with coils all on one side. Anyone have any sources?
-
Anyone know where to get wider beauty rings that only allow about 1/4" to show between hub cap and beauty ring? All I see are the narrow ones.
-
Thanks for the tips. Skins are already off the caps. New skins are available.
-
On another note. Anyone know where to buy the wide trim rings that cover the entire wheel?
-
Sounds like a plan, I can always use panel bond and let it dry. Pitty the guy who tries to take them apart someday
-
Yes, those are the ones. Looking for insight from someone who has done this.
-
There is a steel hubcap as the base. The decorative skin is applied over the steel one
-
Roberts Motor Parts part # P167 $65.00 each
-
Roberts has the skins, seen them on ebay as well. Looks to be a tricky process to get them conformed with no damage
-
My search skills must be lacking because I'm sure this has been discussed. Need to reskin hubcaps on a 47 Chrysler New Yorker and am looking for tips or even a company that does this.
-
That's a resistor on back of fuel gauge? This car was not 12 volt ( will be soon tho) Plymouthy called it a "noise resistor" the whole piece that the canister is mounted to is what I need. Haven't seen it at any of the parts suppliers
-
-
Found this thread about the "noise suppressor" on back of fuel gauge. Anyone know where to get one? Mine is broken. Thanks
