About This File
This template can be used to trace and cut out the masticated rubber seals between the Front, INNER fenders, and the frame.
They are stapled on to each inner fenders ( driver and passenger ).
I was lucky to purchase both inner fenders NOS with the original rubber seals attached. I am sharing them here for your use. I have benefited from help here on other templates so I am paying it forward.
Instructions:
Purchase a sheet / roll of masticated rubber. 1/8 " thick min. ( like tire rubber with poly cord imbedded )
Print the templates on LEGAL size paper ( 8.5 " X 14 ")
Match the two pages where shown and tape the sheets together.
Cut out the template
Trace on to the rubber sheet ( bright color pen / marker )
Cut out the rubber seal.
I used heavy gauge stainless steel wire to make the " staples " and wired the seals to the inner fenders.
Note: my D24 is a Club Coupe, I believe the front fenders are the same on other Models and maybe Chysler's other lines.
Good Luck !
Clay Janer
Conn47D24
Recommended Comments
There are no comments to display.
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.