George Asche Multi-Carb Manifold

[Jim Shepard]

I was just re-reading a very old thread where George Asche and Tim Kingsbury were going to start casting dual and triple carb manifolds for the 25” and 23” flatheads. I don’t think they ever produced any of the triples for the smaller engine but they apparently did make some for the 25” engine. At one point in the development I understand they were considering the pros and cons of casting the bosses to accommodate the linkage for both a car and truck application. Don’t know if they actually did this but, if so, did anyone on the Forum actually ever put one of these on a Pilothouse truck?