garyvond Posted August 31, 2014 Report Posted August 31, 2014 I'm rebuilding the master cylinder on mty sons 48 dodge, and I can't seem to figure out where this rubber washer/seal goes. I don't see it in the illustration, and no matter where I put it I can't seem to get any pressure. Any help would be greatly appreciated. thanks. Quote
Mike Posted August 31, 2014 Report Posted August 31, 2014 (edited) Thats the first part that slides back in before the valve on the diagram, I just rebuilt my plymouth had same issue till I fished the old one out with a screw driver and matched it up Edited August 31, 2014 by Mike Quote
garyvond Posted September 1, 2014 Author Report Posted September 1, 2014 (edited) OK thanks MIke. Does it go between the valve and spring, or between the valve and plug? Edited September 1, 2014 by garyvond Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.