Search the Community

Working on a friends 1954 C1-B6 Job rated Pickup. I need wheel cylinders front and back and am having a hard time coming up with the correct part numbers. Any help is appreciated THANKS Randy L Peterson

Hi all, A couple of months ago I picked up a 3/4 ton that's pretty straight, complete and original for $1800. It's got a rebuilt engine (receipts, looks and sounds good), though most of the "peripherals" need attending to. I'm rebuilding the carb, new fuel pump, rebuilt starter (old one would sometimes grind). No rust to speak of, but it's been sitting for over 20 years (fuel tank being cleaned/repaired). Keven's been very helpful and did a beautiful job on my speedo and gauge cluster. This is my eleventh old pick-up ('25 Dodge - '57 Ford), and while I've done all kinds of work on these old timers, I am to a large extent still a "learner." I've also been without a truck for 20 years while in family mode (though I've had dreams about my '27 Chevy and my '35 Dodge). My dad's been coming over once a week and helping on various projects. Today we pulled off the front wheel to take a peek at the brake situation. I'm familiar with the basics, but my dad had a concern about what we were looking at in terms of the spindle. There's some torn thin metal surrounding the base and a bit of a groove as well. I'd be grateful for any comments regarding this. I'd also be grateful for suggested resources for new cylinders (front and rear) and possibly drums, bearings, etc. I'm also including a shot of the rear drum. I'm used to seeing some gap between the drum and the rear plate, but this seems a bit much. Any thoughts? Attachments: 1. Front spindle showing torn metal and groove in spindle. 2. Drum with rear spindle in place (pressed?). 3. Rear drum showing gap between drum and backing plate. With thanks, Ralph San Jose, CA